Shining Powder

Features + Benefits
Creates high shine finish
Brings back luster of polished stone
Non-acidic

Where to Use
Natural stone such as marble, limestone, travertine & terrazzo.

Directions
Always test in a small inconspicuous area to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings.

1. If surface is heavily soiled, pre-clean with KlenzAll™ if needed.
2. Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
3. If using Shining Powder following the use of Polishing Powder, insure that the surface is well rinsed and a new pad is used.
4. Insure surface is flat and smooth. Deep scratches or strong acid etching may require refinishing with Honing Powder and / or Polishing Powder prior to using Shining Powder.
5. Apply approximately 1/2 cup Shining Powder plus 1 cup clean water to stone surface.
6. Refinish area with hand buffer or weighted floor machine at 130-140 lbs., 175 rpm, fitted with a natural hair pad.
7. Keep Shining Powder wet with water while refinishing. Add Shining Powder as needed.
8. Refinish area until desired level of shine is achieved.
9. Rinse well and use wet vacuum or hot water extraction unit to remove all remaining Shining Powder.
 

Available Sizes (and Coverage)
1.5 lb Canister: 500-1,000 sq. ft. per pound.

Related Products
To maintain your stone’s natural beauty, clean surface as needed with Revitalizer™ Cleaner and Protector or the economical Stone & Tile Cleaner.